|
•
|
To use a Softube Amp as an insert fx when you're recording an audio track, you need to monitor through Reason (see “Monitoring”) - otherwise you won't hear the sound of the Softube Amp during recording.
|
For this to feel comfortable you will want as low latency as possible (see “Buffer Size settings”). With good audio hardware and drivers, you can usually get down to a latency of a few milliseconds, which is about the same delay you'd get standing a meter from a real guitar amplifier.
The Softube Amps front panel can be divided into two main sections; the display area with Patch/Amp/Cabinet selectors at the top, and a set of standard amplifier tone controls below. The Amp parameters (tone controls) are described in “Amp panel controls”.
While the specific parameters for the Softube Amps are described later in this chapter, some features and procedures are common to all effect devices. Please, refer to “Common effect device features” for information about the Input meter, the Bypass/On/Off switch and Signal Flow Graphs on the Softube Amps.
Loading and saving patches in the Softube Amps is done in the same way as with any other Reason/Reason Essentials device - see “Sounds, Patches and the Browser” for more details.
You can use any Amp model with any Cabinet + microphone model. For general model descriptions see “About the Amp and Cabinet models”.
|
| Control
|
|
|
| Control
|
|
